Jailbreak 4.3.5 right now for free! This post will walk you through the simple steps needed to Jailbreak 4.3.5. Jailbreaking allows you to take full control of your iPhone, iPad or iPod Touch and it’s very easy to do and best of all it isn’t harmful to your device!

Steps (for Mac and PC users):


1. Download Redsn0w, iOS 4.3.5 and iOS 4.3.4 for your iDevice in the download section below

  • If you’re on Windows Vista or Windows 7 then you need to right click Redsn0w and set compatibility to windows XP (service pack 2) and then run it as an administrator

2. Plug in iDevice and run Redsn0w

3. Browse for your 4.3.4 firmware in Redsn0w and select it (NOT YOUR 4.3.5 FIRMWARE)

4. Hit next and then check install Cydia

5. Enter DFU mode ahead of time to bypass the instruction screen!

a. Hold down the power button for 3 seconds
b. Continue holding the power button and start holding the home button and continue HOLDING BOTH for 10 seconds
c. Let go of power and continue holding home button for 20 seconds (even after it skips to the next screen! YOU MUST COUNT TO 20 ON YOUR OWN)

6. Wait for it to finish and reboot (the video shows how long EVERYTHING takes)

7. Power off your iDevice while its plugged in and then open Redsn0w again

8. Browse for your 4.3.4 firmware again

9. Check off Just boot tethered right now and follow ALL the instructions in step 5

You are now Jailbroken on iOS 4.3.5

NOTE: you will need to run Redsn0w again in the “Just boot tethered right now” mode every time you need to reboot your iDevice and use ANYTHING from Cydia (including Cydia itself) – the same applies for Safari!

If you get a white Cydia icon and or your Safari doesn’t work then simply reboot in Redsn0w’s “Just boot tethered right now” mode!

Downloads:

4.3.4 Firmware (select the firmware that corresponds to your device)
4.3.5 Firmware (select the firmware that corresponds to your device)
Newest Release of Redsn0w:

Windows – Redsn0w 0.9.8b5

Mac – Redsn0w 0.9.8b5